Nubira SX Hatchback L4-2.0L DOHC D-TEC MFI (1999)
3. Center the rack in the housing.
4. Install the valve assembly, the stub shaft bearing annulus assembly and a new stub shaft dust seal into the housing.
IMPORTANT: When the valve and pinion assembly is fully seated in the housing, be sure that the notch in the stub shaft and the mark on the
housing line up.
NOTICE: If the stub shaft is not held, damage to the pinion teeth will occur.
5. While holding the stub shaft, install the locknut onto the pinion shaft.
Tighten
Tighten the pinion locknut to 30 Nm (22 ft. lbs.).
6. Replace the dust cover onto the housing.
7. Install the rack and pinion steering assembly.