Nubira SX Hatchback L4-2.0L DOHC D-TEC MFI (1999)
Shift Cable: Adjustments
CONTROL CABLE ADJUSTMENT
1. Disconnect the negative battery cable.
2. Move the shift lever to PARK.
3. Make sure the transmission range switch on the transaxle is in PARK.
4. Remove the right and the left front lower trim panels, the shift control panel, and the floor console.
5. Loosen the shift control cable adjustment pinch bolt.
6. Pull the shifter control cable until it is tight.
Tighten
Tighten the shift control cable adjustment pinch bolt to 8 Nm (71 inch lbs.).
7. Install the floor console, the shift control panel, and the right and the left lower trim panels.
8. Connect the negative battery cable.