Nubira SX Hatchback L4-2.0L DOHC D-TEC MFI (1999)
2. Spread the snap ring using the snap ring pliers J-8059 and install the outer joint onto the axle shaft.
3. Fill the joint seal with 175 to 195 g (6.2 to 6.9 ounces) of the recommended grease. Repack the joint with 175 to 195 g (6.2 to 6.9 ounces) of the
recommended grease.
4. Install a new large seal retaining clamp and a new small seal retaining clamp.
5. Crimp the new small seal retaining clamp and the new large seal retaining clamp using the seal clamp pliers J-35566.
6. Install the drive axle shaft onto the vehicle. Refer to Axle Shaft Assembly, Constant Velocity Type; Service and Repair.
INNER TRIPOT SEAL
Tools Required
J-8059 Snap Ring Pliers
Removal Procedure
1. Remove the drive axle from the vehicle. Refer to Axle Shaft Assembly, Constant Velocity Type; Service and Repair.