Nubira SX Hatchback L4-2.0L DOHC D-TEC MFI (1999)
7. Remove the shaft retaining ring using the snap ring pliers J-8059.
8. Remove the tripot and the tripot joint retaining ring from the axle shaft.
9. Remove the tripot joint seal from the axle shaft.
Installation Procedure
Tools Required
J-35566 Seal Clamp Pliers
1. Install a new small seal retaining clamp onto the seal. Do not crimp the seal retaining clamp.
2. Install the seal onto the axle shaft.
3. Install the tripot joint retaining ring and the tripot onto the axle shaft.
