Nubira SX Hatchback L4-2.0L DOHC D-TEC MFI (1999)
8. Install a new large seal retaining clamp. Crimp the large seal retaining clamp using the seal clamp pliers J-35566.
9. Crimp the new small seal retaining clamp using the seal clamp pliers J-35566.
10. Install the drive shaft onto the vehicle. Refer to Axle Shaft Assembly, Constant Velocity Type; Service and Repair.
CROSS GROOVE JOINT SEAL
Tools Required
J-35566 Seal Clamp Pliers
J-8059 Snap Ring Pliers
Removal Procedure
1. Remove the drive axle from the vehicle. Refer to Axle Shaft Assembly, Constant Velocity Type; Service and Repair.
2. Remove the large seal retaining clamp. Discard the clamp.
3. Remove the small seal retaining clamp. Discard the clamp.
4. Degrease the joint.
5. Remove the shaft retaining ring using the snap ring pliers J-8059.
