024 L4-135 2212cc 2.2L SOHC VIN B 2-bbl (1982)
^
Raw fuel at carburetor air horn.
^
Good accelerator pump discharge.
^
Will start immediately (unloading technique may be necessary).
PARTS REQUIRED
Three different kits are required with the various fuel gauges and fuel tanks used from 1981 through 1987.
Order one of the respective kit part numbers outlined below:
1981-1983 Models (W/Bi-Metallic Fuel Gauge)
PN 4364380
1984 Models (W/Magnetic Fuel Gauge)
PN 4364381
1985-1987 Models (W/Magnetic Fuel Gauge)
PN 4364382
See detailed parts list attached.
Must order separately:
1
Authorized Modification Label
PN 4275086
Repair Procedure
This repair requires the removal of the mechanical fuel pump and engine mounted fuel lines and the installation of an in-tank electric fuel pump.
A.
Instrument Panel Wiring PN 4304901
All 1981 Through 1987 Models
1.
Disconnect battery.
NOTE:
REMOVE THE CLUTCH CABLE BRACKET FOR MANUAL TRANSMISSION VEHICLES OR SHIFT CABLE
BRACKET FOR AUTOMATIC TRANSMISSION VEHICLES (IF SO EQUIPPED) AT THE LEFT SHOCK TOWER
BEFORE PERFORMING THE NEXT STEP.
2.
Remove engine side of bulkhead connector. Depress fingers on sides of other half of bulkhead connector and push connector back
through hole into passenger compartment.
3.
Remove left side cowl kick panel and left sill scuff plate. Remove fuse block from its mounting location on side cowl.
4.
Remove rear upper and lower seat cushions. On Rampage and Scamp models remove the plastic package tray mounted on rear bulkhead.