1500 4x4 Pickup V8-360 5.9L Magnum (1996)
Wheel Speed Sensor: Service and Repair
Rear
With Rear Wheel Antilock Brakes
REMOVAL
1. Raise vehicle on hoist.
2. Remove brake line mounting nut and remove the brake line from the sensor stud.
Rear Speed Sensor Mounting
3. Remove mounting stud from the sensor and shield.
4. Remove sensor and shield from differential housing.
5. Disconnect sensor wire harness and remove sensor.
INSTALLATION
1. Connect harness to sensor. Be sure seal is securely in place between sensor and wiring connector.
2. Install 0-ring on sensor (if removed).
3. Insert sensor in differential housing.
4. Install sensor shield.
5. Install the sensor mounting stud and tighten to 24 Nm (18 ft. lbs.).
6. Install the brake line on the sensor stud and install the nut.
7. Lower vehicle.
With Four Wheel Antilock Brakes
REMOVAL
1. Raise and support vehicle.
Rear Wheel Speed Sensor
