2500 4x2 Pickup V8-360 5.9L Magnum (1996)
Housing Assembly HVAC: Service and Repair
This procedure may require the removal and installation of the instrument panel and/or some its components. For these procedures, Refer to: Body and
Frame, Interior Trim, Dashboard/Instrument Panel, Service and Repair, See: Body and Frame/Interior Moulding / Trim/Dash Panel/Service and
Repair
Fig 45 Evaporator And Heater Core Lines
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Recover the refrigerant from the refrigerant system.
3. Disconnect the refrigerant lines from the evaporator tubes. Install plugs in, or tape over all of the open refrigerant fittings.
4. Drain the cooling system.
5. Disconnect the heater hoses from the heater core tubes.
6. Remove the coolant reserve/overflow bottle.
7. Remove the Powertrain Control Module (PCM) and set it aside. Do not unplug the PCM wire harness connectors.
8. Remove the nuts that secure the heater-A/C housing mounting studs on the engine compartment side of the dash panel.
9. Remove the instrument panel. Refer to: Body and Frame, Interior Trim, Dashboard/Instrument Panel, Service and Repair, See: Body and
Frame/Interior Moulding / Trim/Dash Panel/Service and Repair
Fig 46 Defroster Duct
10. Remove the defroster duct from the heater- A/C housing.
11. Unplug the heater-A/C housing wire harness connectors.