2500 4x2 Pickup V8-360 5.9L Magnum (1996)
should order the correct EMR Jumper Package for the vehicle being serviced according to the chart below:
Each parts package contains the following components:
Quantity
Description
1
Message Center wiring Jumper
1
Climate Control Module (Not included in transmission oil cooler package)
1
Foam Tape
1
Instruction Sheet
Owner Notification and Service Scheduling
All involved vehicle owners known to Chrysler are being notified of the service requirement by first class mail. They are requested to schedule
appointments for the service with their dealers. A copy of the owner notification letter is included.
Enclosed with each owner notification is an Owner Notification Form. The involved vehicle and recall are identified on the form for owner or dealer
reference as needed.
Completion Reporting and Reimbursement
Claims for vehicles which have been serviced must be submitted on the DIAL System. Claims submitted will be used by Chrysler to record recall service
completions and provide dealer payments.
Use one of the following labor operation numbers and time allowances:
Labor Operation
Time
Number
Allowance
Install message center wiring jumper
08677182
0.3 hours
(For vehicles requiring PN CMA06771)
Replace climate control module and install
08677183
0.4 hours
message center wiring jumper
(For vehicles requiring PN CMA06772 or CMA06773)
Add the cost of the recall parts package plus applicable dealer allowance to your claim.
Note:
See Warranty Policy and Procedure Manual, Chapter 6, Subsection H for complete recall claim processing instructions.
Parts Return Not required.
Vehicle Not Available
If a vehicle is not available for service for a known reason, let us know by filling out the pre-addressed Vehicle Disposition Form portion of the Owner
Notification Form or describe the reason on a postcard and mail to:
Chrysler Corporation
CIMS 482-00-85
800 Chrysler Drive East
Auburn Hills, Michigan 48326-2757
Following the above procedures will expedite the processing of your claim.
If you have any questions or need assistance in completing this action, please contact your Zone Service Office.
Service Procedure
1.
With the ignition key in the OFF position, disconnect the battery.
Note:
To enhance customer satisfaction, remember to record all radio settings before disconnecting the battery and to reset all electronic memory
(clock, radio settings, etc.) when you have completed the service procedure.