2500 4x2 Pickup V8-360 5.9L Magnum (1996)
![background image](/dodge/2500_4x2_pickup/v8-360_5.9l_magnum/Page-646008.png)
1.
Remove the ignition switch mounting screws (Figure 8). Use a tamper-proof torx bit (Snap-on PN TTXR2OA2 or equivalent) to remove the
screws.
2.
Remove the ignition switch from the steering column.
3.
Insert the ignition key into the key cylinder and turn the key to the LOCK position.
4
Depress the key cylinder retaining pin or, if equipped, use the tamper-proof torx bit to remove the key cylinder retaining screw and bracket (Figure
9).
5.
Turn the ignition key to the OFF position. The key cylinder will then unseat from the ignition switch. When the key cylinder is unseated, it will be
approximately 1/8" away from the ignition switch halo light ring. Do NOT attempt to remove the key cylinder at this time.
6.
With the key cylinder unseated, turn the ignition key to the LOCK position and then remove the key.