2500 4x2 Pickup V8-5.9L VIN Z (1994)
Crankshaft Position Sensor: Testing and Inspection
Crankshaft Position Sensor Wiring Connector
NOTE:
To perform a complete test of the Crankshaft Position Sensor (CPS) and its circuitry, refer to the DRB II diagnostic tester. Also see the
appropriate Diagnostic Charts. To test the CPS only, refer to the following:
PROCEDURE
1. Near the rear of the right cylinder head, disconnect CPS wiring harness connector from main wiring harness.
2. Place an ohmmeter across terminals B and C of the CPS connector. The meter reading should be open (infinite resistance). Replace sensor if
resistance is indicated.