2500 4x2 Pickup V8-5.9L VIN Z (1994)
Filter/Regulator Assembly Removal And Installation
6. Remove snap ring retaining the tube cover to filter/regulator. Slide the plastic tube down to clear fuel tube clamp.
Filter/Regulator Assembly Removal And Installation
7. Gently cut fuel tube clamp, take care not to damage plastic fuel tube. Discard old clamp.
8. Remove fuel tube from filter/regulator by pulling downward. Remove filter/regulator from fuel pump module.
INSTALLATION
1. Install new clamp over plastic fuel tube.
2. Install fuel tube on filter/regulator. Rotate filter/regulator until it is in the 10 o'clock position.
Filter/Regulator Assembly Removal And Installation
3. Tighten clamp using special hose clamp pliers number C-4124 or equivalent.
4. Slide plastic fuel tube cover to bottom of filter/regulator and install snap ring.
5. Press the filter/regulator (by hand) into the rubber grommet. Rotate filter/regulator until it is in the 10 o'clock position.
6. Install fuel tank.
7. Lower vehicle.