2500 4x2 Pickup V8-5.9L VIN Z (1994)
Crankshaft Position Sensor: Service and Repair
Crankshaft Position Sensor Location
REMOVAL
1. Disconnect negative battery cable.
2. Remove spark plug cable loom at right rear valve cover.
3. Disconnect two hoses at EGR valve. Note position of hoses before disconnecting.
4. Disconnect electrical connector and hoses at EGR transducer. Note position of hoses before disconnecting.
NOTE: DO NOT pull on sensor electrical lead.
5. Remove 2 EGR valve mounting bolts and remove valve.
6. Disconnect electrical connector at oil pressure sending unit.
Oil Pressure Sending Unit Removal/Installation
7. Using special tool # C-4597 or equivalent remove oil pressure sending unit.
8. Loosen EGR tube mounting nut at the intake manifold. Remove EGR tube mounting bolts at the exhaust manifold and remove EGR tube.
9. Disconnect crankshaft position sensor electrical connector.
10. Remove crankshaft position sensor mounting bolts and remove sensor.
INSTALLATION