2500 4x4 Pickup V8-318 5.2L Magnum (1995)
6. Attach the other jumper wire to the positive side (+) of a 12V power source. Do not connect this jumper wire to relay at this time.
CAUTION: Do not allow the ohmmeter to contact terminals 85 or 86 during these tests. Damage to ohmmeter may result.
7. Attach the other jumper wire (12V +) to terminal number 86. This will activate the relay. Continuity should now be present between terminals
number 87 and 30. Continuity should not be present between terminals number 87A and 30.
8. Disconnect jumper wires from relay and 12 Volt power source.
^
If continuity or resistance tests did not pass, replace relay. If tests passed, refer to wiring diagrams for (fuel system) relay wiring schematics
and for additional circuit information.
