2500 4x4 Pickup V8-360 5.9L VIN 5 Magnum (1994)
Compressor Clutch: Service and Repair
Compressor Clutch / Coil Assembly Replacement
Fig 13 Compressor Shaft Nut Removal/Installation
NOTE: The refrigerant system can remain fully-charged during compressor clutch, pulley, or coil replacement. The compressor clutch can be serviced
in the vehicle.
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. On models with the diesel engine option, remove the compressor. Do not remove the refrigerant lines or fittings.
3. Insert the two pins of the spanner wrench (Special Tool 6462 in Kit 6460) into the holes of the clutch plate. Hold the clutch plate stationary and
remove the hex nut.
Fig 14 Clutch Puller -- Diesel Models
4. Remove the clutch plate. On models with the diesel engine option, a puller (Special Tool 6461 in Kit 6460) is used to remove the clutch plate.
This compressor also uses a shaft key which must be removed.