2500 4x4 Pickup V8-5.2L CNG VIN T (1996)
Solenoid Harness Case Connector Shoulder Bolt
20. Attach solenoid case connector to 3-4 accumulator with shoulder-type screw. Connector has small locating tang that fits in dimple at top of
accumulator housing. Seat tang in dimple before tightening connector screw.
21. Install solenoid assembly and gasket. Tighten solenoid attaching screws to 8 Nm (72 inch lbs.) torque.
Solenoid Harness Routing
22. Verify that solenoid wire harness is properly routed. Solenoid harness must be clear of manual lever and park rod and not be pinched between
accumulator housing and cover.
3-4 Accumulator Assembly Installation
Converter Clutch And 3-4 Shift Valve Springs
1. Position converter clutch valve and 3-4 shift valve springs in housing.