3500 4x4 Pickup L6-359 5.9L DSL Turbo (1996)
Double Cardan Cross Press
2. A vise and a cross press tool, can be used in place of the socket to drive out bearings.
3. Support driveshaft horizontally inline with the base plate of a press. Place rear end of coupling yoke over a 1 1/8 inch socket to accept bearing.
Place a socket slightly smaller than bearing on opposite side of spider.
Double Cardan Bearing Cup Removal
4. Press bearing cup out of coupling yoke ear. If bearing cup is not completely removed, insert spacer tool No. C-4365-4, or equivalent, and
complete removal of bearing cup.
5. Rotate driveshaft 180° and shear the opposite retaining ring, and press the bearing cup out of the coupling yoke as described previously, using
spacer tool No. C-4365-4, or equivalent.
6. Disengage cross trunnions, still attached to flange yoke, from coupling yoke.