3500 4x4 Pickup L6-359 5.9L DSL Turbo (1996)
Brake Light Switch: Service and Repair
Removal
1. Pull connector from switch, then remove switch from bracket by depressing brake pedal and rotating switch counterclockwise 1/8 turn.
2. Pull switch rearward and remove from bracket.
Installation
1. Ensure adjustable switch plunger is fully extended by pulling out until plunger reaches end of travel. Plunger end should extend approximately 3/4
inch from switch collar.
2. With brake pedal depressed, align key on switch locking collar with slot in mounting bracket square hole, then press switch forward into bracket
until collar seats flush to bracket.
3. Rotate switch clockwise 1/8 turn, then release brake pedal. Switch plunger will adjust to correct setting.
4. Plug connector into switch.