3500 4x4 Pickup V10-488 8.0L Magnum (1994)
Fig. 15 Caliper Dust Boot Installation
6. Seat new dust boot in caliper with appropriate installer tool, No. 6755 or equivalent.
7. Finish pressing caliper piston to bottom of bore after dust boot is seated.
8. Lubricate and install caliper mounting bolts, collars, bushings and bores with suitable silicone grease, then install seals and boots.
9. Install but do not fully tighten caliper bleed screw.
10. Install inboard brake pad, ensuring spring clip is centered and seated.
11. Install outboard brake pad, aligning pad and retaining spring in caliper. Push pad downward into place, ensuring spring ends are correctly seated in
caliper dimples.