3500 4x4 Pickup V10-488 8.0L Magnum (1994)
1994 and 1995
CLUN7632
Each parts package contains the following components:
Quantity
Description
1
Vapor Canister
1
Purge Solenoid
Owner Notification and Service Scheduling
All involved vehicle owners known to Chrysler are being notified of the service requirement by first class mail. They are requested to schedule
appointments for this service with their dealers. A copy of the owner notification letter is included.
Enclosed with each owner notification is an Owner Notification Form. The involved vehicle and recall are identified on the form for owner or dealer
reference as needed.
Completion Reporting and Reimbursement
Claims for vehicles which have been serviced must be submitted on the DIAL System. Claims submitted will be used by Chrysler to record recall service
completions and provide dealer payments.
Use the following labor operation number and time allowance:
Replace vapor canister and purge solenoid
Labor Operation Number
Time
25763182
0.4 hours
Add the cost of the recall parts package plus applicable dealer allowance to your claim.
Note:
See the Warranty Administration Manual, Recall Claim Processing Section for complete recall claim processing instructions.
Parts Return
Not required.
Vehicle Not Available
If a vehicle is not available for service for a known reason, let us know by filling out the pre-addressed Vehicle Disposition Form portion of the Owner
Notification Form or describe the reason on a postcard and mail to:
Chrysler Corporation
CIMS 482-00-85
800 Chrysler Drive East
Auburn Hills, Michigan 48326-2757
Following the above procedures will expedite the processing of your claim.
If you have any questions or need assistance in completing this action, please contact your Zone Service Office.
A. Replace Vapor Canister and Purge Solenoid
1.
With the ignition key in the OFF position disconnect the battery.
Note:
To enhance customer satisfaction remember to record all radio settings before disconnecting the battery and to reset all electronic memory (clock
radio settings etc.) when you have completed the service procedure.
2.
Remove the air cleaner assembly from the throttle body.