3500 4x4 Pickup V10-488 8.0L Magnum (1994)
13. Pull the headlamp switch control knob out to the ON position stop.
14. Depress the switch knob and shaft release button on the bottom of the switch assembly and then pull the switch knob and shaft out of the
switch.
Fig. 5
15. Remove the three screws that secure the headlamp switch bezel to the switch mounting bracket and then remove the bezel. Unscrew the plastic
mounting bracket (shaft bushing) nut and remove the bezel mounting bracket from the switch assembly. Discard the switch assembly.
B. Install the Parklamp Circuit Overlap Harness:
1. Remove the wedge from the 9-way headlamp switch wiring connector.
Fig. 6
2. Inspect the 9-way headlamp switch connector and all nine (9) terminals for indications of heat damage.