3500 4x4 Pickup V10-488 8.0L Magnum (1994)
Camshaft Position Sensor: Service and Repair
Camshaft Position Sensor Location
REMOVAL
1. Disconnect negative battery cable.
2. Disconnect sensor electrical connector.
3. Remove sensor mounting bolt.
4. Using two small screwdrivers, carefully pry sensor from timing chain cover.
5. Remove sensor from vehicle.
6. Inspect condition of o-ring.
INSTALLATION (New Sensor)
1. Apply a small amount of clean motor oil to sensor o-ring.
2. Install the sensor into the timing cover with a slight rocking motion. Push the sensor all the way into the cover until the rib material on the sensor
contacts the cam gear.
3. Install sensor mounting bolt and torque to 6 Nm (50 in-lbs).
4. Connect sensor electrical connector.
Camshaft Position Sensor Installation