3500 4x4 Pickup V8-360 5.9L Magnum (1996)
Fuel Tank Mounting (Typical)
9. Lower fuel tank for removal.
TANK INSTALLATION
1. Place fuel tank on top of transmission jack.
2. Raise tank into position in the frame crossmembers.
3. Connect the two mounting straps and mounting strap nuts.
4. Remove transmission jack. Tighten strap nuts 41 Nm 30 ft. lbs. torque. Do not over tighten retaining strap nuts.
5. Gas Powered Engines:
a. Connect the electrical connector to the fuel pump module.
b. Connect the EVAP hose at the pressure relief/rollover valve.
c. Connect the fuel supply line at the fuel filter fuel pressure regulator.
6. Diesel Powered Engines:
d. Connect the electrical connector to the fuel tank module.
e. Connect the fuel supply and fuel return lines at the fuel tank module.
6. Install the rubber fill and vent lines to tank. Tighten hose clamps to 2.3 Nm 20 in. lbs. torque.
7. Refill fuel tank and inspect all hoses and lines for leaks.
8. Connect negative battery cable to battery.