400 L4-156 2.6L (1982)
FIGURE 4 - FUEL RESERVOIR & PRESSURE REGULATOR CONNECTIONS WITHOUT FUEL FLOW SENSOR
2.
Remove the vapor return hose between the fuel pump and chassis return line. Install the Y connector/hose assembly, PN 4307397, with the
curved leg of the Y connector pointing straight up. Connect the three hoses to the fuel pump vent, reservoir vent, and chassis fuel return line
using three hose clamps, PN 6500650 (Figure 4). Torque to 10 inch pounds.
3.
Remove the thermostat housing bolt closest to the carburetor (already removed in Step 1, if car had a reservoir) and coat threads with
Loctite/Mopar Sealant, PN 4318034. Install the reservoir assembly, PN 4307358, to the thermostat housing using the bolt just removed.
Retorque the bolt to 15 foot pounds (Figure 4-A).