Avenger V6-25L VIN N (1998) Temperature Sensor Specifications
Temperature Sensor (Gauge): Testing and Inspection
1. Drain the engine coolant.
2. Remove the engine coolant temperature gauge unit.
3. Immerse the unit in 70°C (158°F) water to measure the resistance.
Standard value: 104 ±13.5 Ohm
4. If within the standard value, the sensor is OK. Re-install it, then check the engine coolant temperature gauge. If not within the standard value,
replace it. See: Temperature Gauge/Testing and Inspection/Initial Inspection and Diagnostic Overview/Resistance Inspection
5. After checking, apply the specified adhesive around the thread of engine coolant temperature gauge unit.
Specified sealant:
MOPAR Part No.4318031 (Lock Nut Seal Adhesive) or equivalent <DOHC>
MOPAR Part No. 4318034 or equivalent <SOHC>
6. Fill engine coolant.