Avenger V6-2.7L (2008)
Wiper Switch: Service and Repair
Installation
INSTALLATION
1. Position the right multi-function switch (2) close enough to the mounting bracket (3) integral to the right side of the clockspring to reconnect the
jumper wire harness connector (1) to the connector receptacle on the inboard side of the switch housing.
2. Align the slide tab on the bottom of the switch housing with the channel integral to the clockspring mounting bracket, then slide the switch into the
bracket until it is firmly seated.
3. Install and tighten the screw (2) that secures the mounting tab on the back of the right multi-function switch (1) to the mounting bracket on the
clockspring (3).
4. Reinstall the upper and lower shrouds onto the steering column. See: Steering and Suspension/Steering/Steering Column/Steering Column
Cover/Service and Repair/Shroud - Lower/Installation and See: Steering and Suspension/Steering/Steering Column/Steering Column
Cover/Service and Repair/Shroud - Upper/Installation.
5. Reconnect the battery negative cable.
