Avenger V6-2.7L Flex Fuel (2009)
Seat Heater Control Module: Service and Repair
Heated Seat Module - Installation
Heated/Cooled Systems
INSTALLATION
CAUTION: The Heated Seat Module mounting tab can be damaged during module removal and installation. Use care to properly align tab to
prevent binding that could result in tab breakage.
1. Install the heated seat module (3) into the vehicle.
2. Position the retaining tab (2) with the mounting hole in the seat pan (1). Firmly apply even pressure to the module (3) until the mounting tab is
fully seated.
3. Connect the wire harness connector (4) to the heated seat module (3).
4. Connect the battery negative cable.
5. Check for proper heated seat system operation.
Electronic Control Modules
INSTALLATION
CAUTION: The Heated Seat Module mounting tab can be damaged during module removal and installation. Use care to properly align tab to
prevent binding that could result in tab breakage.
1. Install the heated seat module (3) into the vehicle.
2. Position the retaining tab (2) with the mounting hole in the seat pan (1). Firmly apply even pressure to the module (3) until the mounting tab is
fully seated.