Avenger V6-2.7L Flex Fuel (2009)
9. Install the blend door pivot lever (3) onto the end of the blend door pivot shaft (4) located on the left side of the air distribution housing (2). Make
sure the lever retaining tab is fully engaged to the pivot shaft.
NOTE: Align the pin on the blend door lever with the groove in the pivot lever prior to installation of the blend door lever.
10. Install the blend door lever (1) onto the air distribution housing. Make sure the levers are correctly aligned to each other.
11. Position the blend door actuator (2) onto the left side of the air distribution housing (3). If necessary, rotate the actuator slightly to align the splines
on the actuator output shaft with those in the blend door lever.
12. Install the screws (1) that secure the blend door actuator to the air distribution housing. Tighten the screws to 2 Nm (17 in. lbs.).
13. If equipped with the 2.0L diesel engine, install the electric positive temperature coefficient (PTC) heater unit into the air distribution housing (2) .
14. Install the heater core into the air distribution housing See: Heater Core/Service and Repair/Installation.
15. Install the air distribution housing onto the HVAC housing (1) See: Removal and Replacement/HVAC Housing - Installation.
16. Install the HVAC housing assembly See: Removal and Replacement/HVAC Housing - Installation.