Avenger V6-3.5L (2008)
3. Install the tire and wheel assembly (1) See: Wheels and Tires/Service and Repair/Removal and Replacement/Tires and Wheels - Installation.
Install and tighten the wheel mounting nuts (3) to 135 Nm (100 ft. lbs.).
4. Lower the vehicle.
5. Position the vehicle on an alignment rack/drive-on lift. Raise the vehicle as necessary to access mounting bolts and nuts.
6. Tighten the upper control arm mounting bolt nut at the crossmember to 105 Nm (77 ft. lbs.).
7. Tighten the upper control arm mounting bolt nut at the knuckle to 105 Nm (77 ft. lbs.).
8. Perform wheel alignment as necessary. See: Alignment/Service and Repair
Rear Lower Control Arm - Removal
REMOVAL
1. Raise and support the vehicle. See: Maintenance
2. Remove the wheel mounting nuts (3), then the tire and wheel assembly (1).