Avenger V6-3.5L (2008)
8. Install the shock absorber (13) up through the bottom of the coil spring (11) and upper mounting bracket until the lower spring seat contacts the
lower end of the coil spring.
9. While holding the shock absorber in position, install the washer (2) and nut (1) on the end of the shock rod.
CAUTION: Never use impact or high speed tools to remove the shock rod nut. Damage to the shock internal bearings can occur.
10. Install Snap-On(R) Shock Absorber Socket A139, or equivalent, on the end of the shock rod (1). While holding the shock rod from turning, tighten
the nut (2) using a crows foot wrench and a torque wrench. Tighten the shock rod nut to 41 Nm (30 ft. lbs.).
11. Turn the upper mounting bracket or shock absorber as necessary until the mounting studs on the mounting bracket line up with the lower mounting
bolt eyelet at the bottom of the shock absorber.
12. Slowly release the tension from the coil spring by backing off the compressor (1) drive completely.
13. Remove the shock assembly from the spring compressor.
14. Install the shock assembly on the vehicle. See: Installation
Installation
INSTALLATION
