Avenger V6-3.5L (2008)
Wheel Bearing: Service and Repair
Rear Hub / Bearing - Installation
All-Wheel-Drive
ALL-WHEEL-DRIVE
1. Slide the hub and bearing over the axle half shaft and position it on the brake support plate and trailing link.
2. Install the four bolts (1) securing the hub and bearing to the knuckle. Tighten the bolts to 105 Nm (77 ft. lbs.).
3. Clip the wheel speed sensor head (1) (flat side to bearing rear) into the retainer on the rear of the hub and bearing (2).
4. Slide the brake rotor (3) over the parking brake shoes and onto the hub and bearing (1).