dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Engine - Lacks Power/Hard Starting When Cold|Page 2334 > < Engine - Lacks Power/Hard Starting When Cold|Page 2332
Page 1
background image

Fuel Pressure Regulator: Service and Repair

Pressure Relief/Rollover Valve

NOTE:  On this engine the fuel filter and fuel pressure regulator are one combined part. 

WARNING:  The fuel system is under constant pressure, even when the engine is OFF. Always release fuel pressure before servicing any fuel
system component.
  

REMOVAL

1.

Release fuel system pressure.  See: Fuel Filter/Fuel Pressure Release/Service and Repair

2.

Disconnect negative battery cable.

3.

Raise and support vehicle.

4.

Drain fuel tank and remove tank.

Filter/Regulator Assembly Removal And Installation

5.

The fuel filter/regulator assembly is pressed into a rubber grommet. Remove by twisting and pulling strait up.

CAUTION:  Do not pull filter/regulator more than three inches from fuel pump module. Damage to coiled fuel tube may result.

Engine - Lacks Power/Hard Starting When Cold|Page 2334 > < Engine - Lacks Power/Hard Starting When Cold|Page 2332