B350 1 Ton Van V8-5.9L VIN Z (1992)
Weatherstrip Seal Adhesive
1. Apply weatherstrip seal adhesive to the door inner panel around the perimeter of the door.
2. Position the weatherstrip seal on the door.
3. Start at either upper corner of the door. Simultaneously move lateral and downward around the perimeter of the door while inserting the seal
retainers in the panel holes.
4. Move lateral and downward around the perimeter of the door and press the seal firmly and uniformly against the door inner panel.
NOTE: Seal positioning at the corners is critical. The seal must be firmly "seated" at each corner. Avoid "puckering" and stretching the seal at the
corners.
5. Remove excess adhesive with and appropriate removal solution.
6. Inspect the fit of the door in the body door opening and the adjacent door. If crushed, the seal will rapidly deteriorate. If not correct, adjust the
door- to-body fit so that the seal is not crushed when the door is closed. Refer to the door adjustment procedure.
Left Door-To-Body Weatherstrip Seal
LEFT DOOR WEATHERSTRIP REMOVAL
1. Open both cargo doors.
2. Remove the seal-end retainers from both inboard ends of the seal.
3. Start at the upper, inboard corner and pull upward on the seal to separate the retainers from the holes in the door inner panel.
4. Continue around the perimeter of the seal and pull outward on the seal to separate the retainers from the holes in the door inner panel and the
adhesive.
5. Remove the seal from the door.
6. Remove the residual adhesive from the door inner panel.
INSTALLATION
The door-to-body weatherstrip seal is installed by inserting the integral retainers in the door inner panel holes and installing the seal-end retainers.