Caliber L4-1.8L (2009)
Alarm Module: Service and Repair
Sentry Key Immobilizer Module (SKREEM) - Installation
INSTALLATION
When a PCM and the SKREEM/WCM are replaced at the same time, perform the following steps in order See: Keyless Entry/Keyless Entry
Module/Testing and Inspection/Programming and Relearning.
-
Program the new PCM.
-
Program the new SKREEM/WCM.
-
Replace all ignition keys and program them to the new SKREEM/WCM.
1. Position the SKREEM/WCM (3) on the ignition lock housing and install the retaining screw (2).
2. Connect the SKREEM/WCM electrical connector (4).
NOTE: On vehicles equipped with the optional Sentry Key Immobilizer System (SKIS), when the SKREEM is replaced with a new unit, a
diagnostic scan tool MUST be used to initialize the new SKREEM and to program at least two Sentry Key transponders before the
vehicle can be operated . See: Alarm System Transponder/Testing and Inspection
3. Connect the battery negative cable.