Caliber L4-2.4L (2009)
Turbo Boost Gauge: Service and Repair
Boost Gauge - Removal
REMOVAL
1. Open hood, disconnect and isolate the battery negative cable.
WARNING: Wait two minutes for the airbag system reserve capacitor to discharge before beginning any airbag system or component service.
Failure to do so may result in accidental airbag deployment, and potentially serious or fatal injury.
2. Remove the instrument panel end caps See: Dashboard / Instrument Panel/Service and Repair/Instrument Panel End Cap - Removal.
3. Remove the knee blocker airbag (if equipped) See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Removal and
Replacement/Knee Blocker Air Bag - Removal.
4. Remove the steering column opening cover See: Dashboard / Instrument Panel/Service and Repair/Steering Column Opening Cover - Removal.
5. Remove the instrument panel center bezel See: Dashboard / Instrument Panel/Service and Repair/Instrument Panel Bezel - Removal.
6. Remove the A-pillar trim, both right and left sides See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar
Trim/A-Pillar Trim Panel-Removal.
7. Remove the instrument panel top cover See: Dashboard / Instrument Panel/Service and Repair/Instrument Panel Cover - Removal.
8. Loosen the instrument panel upper panel enough to lift the left side up to remove the boost gauge wiring and electrical connector.See: Dashboard /
Instrument Panel/Service and Repair/Instrument Panel Pad - Removal.
9. Disconnect the one electrical connector (2) the boost gauge.