Caliber L4-2.4L (2009)
Power Distribution Module: Service and Repair
Power Inverter Module - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow
these instructions may result in accidental airbag deployment and possible serious or fatal injury.
1. Disconnect and isolate the negative battery cable.
2. Remove the shift bezel. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Shifter Bezel - Removal
3. Remove the center bezel from the instrument panel. See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Instrument Panel Bezel - Removal.
4. Remove the fasteners from the mounting brackets of the inverter module.
5. Disconnect the electrical connectors and remove the inverter module.
