Caliber L4-2.4L (2009)
Wiper Switch: Service and Repair
Right Multifunction Switch - Removal
REMOVAL
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component
diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper
precautions could result in accidental airbag deployment.
1. Disconnect and isolate the battery negative cable.
2. Remove both the upper and lower shrouds from the steering column See: Steering and Suspension/Steering/Steering Column/Steering Column
Cover/Service and Repair/Steering Column Shroud - Removal and See: Steering and Suspension/Steering/Steering Column/Steering Column
Cover/Service and Repair/Steering Column Shroud - Removal.
3. Remove the screw (2) that secures the right multi-function switch (1) to the mounting bracket integral to the right side of the clockspring (3) on the
steering column.
4. Slide the switch away from the clockspring far enough to disengage the slide tab on the bottom of the switch housing from the channel formation
in the mounting bracket.
5. Disconnect the jumper wire harness connector (1) from the connector receptacle on the inboard end of the right multi-function switch (2).
6. Remove the switch from the clockspring (3).