Caliber SRT-4 L4-2.4L Turbo VIN F (2007)
Keyless Entry Module: Service and Repair
Installation
INSTALLATION
When a PCM and the SKREEM/WCM are replaced at the same time, perform the following steps in order.
-
Program the new PCM.
-
Program the new SKREEM/WCM.
-
Replace all ignition keys and program them to the new SKREEM/WCM.
1. Position the SKREEM/WCM (3) on the ignition lock housing and install the retaining screw (2).
2. Connect the SKREEM/WCM electrical connector (4).
NOTE: On vehicles equipped with the optional Sentry Key Immobilizer System (SKIS), when the SKREEM is replaced with a new unit, a
diagnostic scan tool MUST be used to initialize the new SKREEM and to program at least two Sentry Key transponders before the vehicle can be
operated.
3. Connect the battery negative cable.
