Caliber SRT-4 L4-2.4L Turbo VIN F (2007)
SPECIAL TOOLS / EQUIPMENT REQUIRED:
REPAIR PROCEDURE - USING THE INTERNET TO RETRIEVE THE FLASH FILE:
CAUTION:
DO NOT START THE ENGINE PRIOR TO COMPLETING **STEP 5n and/or 8h**. IF THE PROCEDURE IS NOT ADHERED TO THE
CONTROLLERS MAY NOT COMPLETE THE PROGRAMMING PROCESS.
NOTE:
When performing this Repair Procedure, the software release level in the StarSCAN(R); must be programmed with 7.02 SP2 software or higher. The
software release level is visible in the blue header at the top of the StarSCAN(R) screen.
PM/MK Models equipped with a CVT must have the TCM reprogrammed as follows:
6.
Using the StarSCAN(R) at the "Home" screen:
a.
Select "ECU View"
b.
Touch the screen to highlight the TCM in the list of modules.
c.
Select "More Options"
d.
Select "ECU Flash"
e.
Record the part number at the top of the "Flash TCM" screen for later reference.
f.
Select "Browse for New File". Follow the on screen instructions.
7.
Is the TCM part number recorded in step 6e above, the same as the new p/n shown on the "Flash File List" screen?
a.
Yes >> No further action is necessary. Proceed to Step 9.
b.
No >> the TCM will require flash reprogramming, proceed to Step 8.
8.
Flash reprogram the TCM as follows:
a.
From the "Flash File List" screen, select "Download to Scantool".
b.
Select "Close" after the download is complete, then select "Back".
c.
Highlight the listed calibration.
d.
Select "Update Controller". Follow on screen instructions.
e.
When the update is complete, select "OK".
f.
Verify the part number at the top of the "Flash TCM" screen has updated to the new part number.
g.
Turn the ignition switch to the OFF position for no less than 15 seconds.
h.
Turn the ignition switch to the RUN position (DO NOT CRANK THE ENGINE) for no less than 20 seconds.
