Caravan V6-201 3.3L (1995)
Cylinder Head Gasket: Service and Repair
Cylinder Head Removal
Fig. 6 Cylinder Head Assembly
DESCRIPTION
The aluminum alloy cylinder heads shown in Fig. 6 are held in place by 9 bolts. The spark plugs are located in peak of the wedge between the valves.
REMOVAL
1. Drain cooling system and disconnect negative battery cable. Remove intake manifold, and throttle body. Refer to Engine/Intake
Manifold/Service and Repair.
See: Intake Manifold/Service and Repair
2. Disconnect coil wires, sending unit wire, heater hoses and by-pass hose.
3. Remove closed ventilation system, evaporation control system and cylinder head covers.
4. Remove exhaust manifolds.
5. Remove rocker arm and shaft assemblies. Remove push rods and identify to insure installation in original locations.
Fig. 7 Cylinder Head Bolts Location
6. Remove the 9 head bolts from each cylinder head and remove cylinder heads Fig. 7.
INSPECTION
1. Before cleaning, check for leaks, damage and cracks.
2. Clean cylinder head and oil passages.