Caravan V6-201 3.3L (1995)
Constant Velocity Joint: Service and Repair
Inner CV Joint
Disassembly
Driveshaft assembly should be identified before starting service procedure.
On some models when removing housing from tripod, it may be necessary to hold rollers in place on trunnion studs to prevent needles and rollers from
falling out.
1. Remove boot clamps and pull back boot.
Fig. 9 Tripod Removal From Housing
2. On models with S.S.G. driveshafts, pry wire ring tripod retainer from groove around top of housing using a suitable flathead screwdriver. Do not
distort or damage retainer ring.
3. On all models, clamp shaft of CV joint housing in a vise. Use protective caps on jaws of vice to prevent damage to shaft.
