Caravan V6-3.3L VIN R (2003)
8. Remove door latch from door.
INSTALLATION
NOTE: The screws attaching the door latch to the door end frame have nylon patches on the threads. All screws must be replaced when the latch has
been removed.
1. Insert inside handle latch link to door latch and engage clip (Fig. 18).
2. Place door latch in position on door end frame.
3. Install screws attaching door latch to door end frame. Tighten screws to 10 N.m (90 in.lbs.) torque (Fig. 19).
4. Insert other linkages to door latch and engage clips.
5. Connect wire connector into power door lock motor, if equipped.
6. Insert a hex wrench through the elongated hole located in the door shut face above the latch.
7. Loosen alien head screw.
8. Pull outward on the outside door handle and release.
9. Tighten alien head screw.
10. Verify door latch and power door lock operation.
11. Install watershield and front door trim panel.
