Caravan V6-3.3L VIN R (2003)
INSTALLATION - PARKING BRAKE LEVER AND FRONT CABLE
1. Pass the parking brake cable down through the hole in the floor pan from inside of vehicle.
2. Pass cable end button through the hole in the lever bracket and press the cable housing into the hole until all three retaining fingers lock the cable
to the lever bracket.
3. Hook the end of the parking brake cable on the parking brake lever mechanism.
4. Press the cable grommet into the hole in the floor pan and install the three screws securing it to the floor pan.
5. If equipped with a manual transaxle, install the gearshift mechanism.
6. Install the floor console.
7. Raise the vehicle.
8. Install the four mounting nuts securing the parking brake lever bracket in place.
9. Install the front park cable housing retainer to the body outrigger bracket. Press the cable housing into the outrigger hole until all three retaining
fingers lock the cable in place.
10. Grasp the exposed section of the front parking brake cable and pull rearward on it. While holding the park brake in this position, install a pair of
locking pliers on the front parking brake cable just rearward of the second body outrigger bracket.
11. Install the equalizer on the front parking brake cable and install the left rear and intermediate park brake cable in the correct location on the
parking brake cable equalizer.
12. Remove the locking pliers from the front parking brake cable. This will allow the adjuster in the park brake lever mechanism to tension the parking
brake cables.
13. Lower the vehicle.
14. Apply and release the parking brake lever one time. This will seat the parking brake cables and allow the auto adjuster in the parking brake lever
mechanism to correctly tension the parking brake cables.
