Caravan V6-3.3L VIN R (2003)
Air Bag Control Module: Service and Repair
Side Impact Airbag Control Module
REMOVAL
NOTE: Diagnose the SIACM using the service/diagnostic manual.
1. Disconnect and isolate the battery negative cable terminal.
2. Remove the lower B-pillar trim from the appropriate side of the vehicle. Refer to Body, Interior, B-Pillar Lower Trim, REMOVAL.
3. Remove the three SIACM retaining screws and remove the module from the vehicle.
4. Disconnect the SIACM electrical connector.
INSTALLATION
WARNING: DO NOT INSTALL THE SIACM IF THE MOUNTING LOCATION IS DEFORMED OR DAMAGED.
1. Connect the SIACM electrical connector.
2. Place the module in the slot on their respective B-pillar. Install the three SIACM retaining screws. Torque screws to 5.7 - 7.9 Nm (50 - 70 lbs.).
CAUTION: Use the correct screws when installing the SIACM.
3. Install the lower B-pillar trim on the appropriate side of the vehicle. Refer to Body, Interior, B-Pillar Lower Trim, INSTALLATION.
WARNING: DO NOT CONNECT THE BATTERY NEGATIVE CABLE. REFER TO ELECTRICAL, RESTRAINTS, DIAGNOSIS AND
TESTING - AIRBAG SYSTEM FIRST.