Caravan V6-3.3L VIN R (2003)
7. Remove tie rod end from steering knuckle using Remover, Special Tool C-3894-A.
8. If equipped with antilock brakes, remove the front wheel speed sensor from the steering knuckle.
9. Remove the two steering knuckle-to-strut clevis bracket attaching bolts.
10. Tip the knuckle outward and remove the driveshaft stub axle from the hub and bearing. Suspend driveshaft straight outward using a bungee cord or
wire. Do not allow driveshaft to hang by inner joint.
11. Remove ball joint nut using a power impact wrench. Because the tapered stud is held sufficiently in the knuckle at this time, it is not necessary to
hold the stud stationary to remove the nut.
12. Reinstall the ball joint nut until the top of the nut is even with the top of the ball joint stud. This will keep the stud from distorting while the stud is
released from the knuckle in the following step.
CAUTION: Do not remove ball joint stud from steering knuckle using a hammer. Damage to the Aluminum knuckle, ball joint or control arm
will result.
