Caravan AWD V6-201 3.3L (1991)
Front Door Panel: Service and Repair
REMOVAL
Front Door Trim
1.
Lower the door glass.
2.
If the vehicle is equipped with power windows, disconnect the battery negative cable.
3.
Remove the screw holding the door latch handle bezel to the door trim panel. Remove the bezel from the door.
4.
Remove the screw holding the upper door trim to the side view mirror frame.
5.
Remove plugs and screws holding the trim to the door above the map pocket.
6.
Remove the plug and screw that holds the bottom rear corner of the trim panel to the door.
7.
Remove the plugs and screws holding the armrest to the trim panel.
8.
Remove the window crank (if equipped with manual windows).
9.
Disengage the trim clips that hold the trim panel to the perimeter door inner panel.
10.
Lift trim panel upwards to disengage barb clips at top of trim panel.
11.
Disconnect courtesy lamp, power window switch, power lock switch electrical connectors (if equipped).
12.
Remove trim panel from door.
INSTALLATION
1.
Connect courtesy lamp, power window switch, power lock switch electrical connectors (if equipped).
2.
Install trim panel by pushing in and down at the same time. Pushing down will engage the barb clips at the top of the trim panel.
3.
Push the trim clips in at the perimeter of the door inner panel.
4.
Install the window crank (if equipped with manual windows).
5.
Install the screws and plugs that hold the armrest to the trim panel.
6.
Install the screw and plug into the bottom rear corner of the trim panel.
7.
Install the screws and plugs that hold the trim panel to the door above the map pocket.
8.
Install the screw holding the upper door trim to the side view mirror frame.
9.
Install the door latch handle bezel and its screw to the door trim panel.
10.
Connect the negative battery cable if it was removed (if equipped with power windows).
