Caravan AWD V6-201 3.3L (1991)
Sliding Door Interior Trim Panel: Service and Repair
REMOVAL
Sliding Door Trim Panel
1.
Close the sliding door.
2.
Remove the plug and screw at the rearward center of door trim panel.
3.
Remove the hidden screw from the upper rearward corner of the carpet insert.
4.
Remove the screws along the bottom of the trim panel used to hold the trim panel to the door.
5.
Disengage the trim clips holding the trim panel to the door. These are located around the perimeter of the door.
6.
Lift up on the trim panel to disengage the barb clips at the top of the trim panel.
7.
Remove the trim panel.
INSTALLATION
1.
Install the trim panel by pushing in and down at the same time (this is done to snap the barb clips into place at the top of the trim panel).
2.
Install the trim clips around the perimeter of the door.
3.
Install the screws along the bottom of the trim panel that hold the trim panel to the door.
4.
Install the hidden screw behind the upper rearward corner of the carpet insert.
5.
Install the screw and plug at the rearward center of the door trim panel (this screw should be installed just under the rear of the sliding door
window).