Caravan AWD V6-201 3.3L (1991)
the OFF position and pump the brake pedal a minimum of 40 times.
10.
Check the fluid level in the reservoir and fill, if necessary, using fresh, clean brake fluid such as Mopar or equivalent, conforming to DOT 3
requirements.
Pump Supply Filter Replacement - AC and AY Body
1.
Remove one reservoir cap.
2.
With the ignition key in the OFF position, discharge the ABS accumulator pressure by pumping the brake pedal a minimum of 40 times.
3.
Install the reservoir cap.
4.
Remove the hose clamps and pump supply filter at the front the actuator assembly (Figure 2). Cap the supply hose leading from the actuator
assembly. Discard hose clamps and filter.
5.
Remove and install the new pump supply filter from the clip on the front of the actuator assembly (Figure 5).
6.
Remove the cap from the supply hose. Install both hoses onto the pump supply filter and torque clamps to 1.0 - 2.0 N-m (9 - 18 in.lbs.).
7.
Turn the ignition key to the ON position and allow the pump to run to purge air from the system. When the pump turns off, turn the ignition key to
the OFF position and pump the brake pedal a minimum of 40 times.
8.
Check the fluid level in the reservoir and fill, if necessary, using fresh, clean brake fluid such as Mopar or equivalent, conforming to DOT 3
requirements.
Testing For Internal Leaks
If an internal leak is suspected in the ABS circuit, a test fixture has been developed to assist in the diagnostics. This fixture will assist in determining if
there is an internal leak, and if the leak is within the hydraulic unit or the pump motor assembly. It can be used whether the pump shuts off or not.
INSTALLING THE INTERNAL LEAK TEST FIXTURE # 6685
1.
With the ignition key in the OFF position, discharge the ABS system by pumping the brake pedal a minimum of 40 times.
