Caravan AWD V6-201 3.3L (1991)
-
If total runout is in exceeds specification check the lateral runout of the hub face.
Fig 2 Marking Brake Disc And Wheel Stud For Reassembly
MEASURING LATERAL RUNOUT OF THE HUB FACE:
1. Before removing disc, make a chalk mark across both the disc and one wheel stud, on the high side of runout, so you'll know exactly how the disc
and hub was originally mounted.
2. Remove disc from hub.
Fig 3 Checking Hub Runout
3. Install dial indicator with adapter on steering arm with stem contacting hub face near outer diameter (care must be taken to position dial indicator
stem outside the stud circle but inside the chamfer on the hub rim. Runout should not exceed 0.05mm (0.002 inch).
-
If runout exceeds this specification, hub must be replaced.
