Caravan AWD V6-201 3.3L (1991)
Removing Or Installing Caliper
6. Carefully lower caliper over disc brake rotor and shoe assemblies.
CAUTION: Use care to avoid cross threading guide pins when installing.
7. Install guide pins through bushing caliper and adapter and tighten to 25-35 ft lb (34-37 Nm).
Removing Or Installing Guide Pin
8. Install wheel and tire assembly. Tighten stud nuts in the proper sequence until all nuts are torqued to half specification. THIS IS IMPORTANT.
Then repeat sequence to full specification.
7. Remove jackstands or lower hoist.
CAUTION: Before moving vehicle, be sure it has a firm pedal.
8. Road test vehicle and make several stops to wear off any foreign material on the brakes and to seat the linings. The vehicle may pull to one side or
the other if this is not done.
